6. FULLY TIGHTEN THE SCREWS NUTS AND WASHERS.
THIS WILL GIVE THE DESIRED CURVE ON THE PANEL.
DURING THIS STAGE, SOME PRESSURE WILL BE REQUIRED ON THE TROLLEY SIDE PANEL TO ALIGN THE HOLES.
ATTACHMENT OF TROLLEY SIDE PANELS
(NOTE: LEAVE THE BARBECUE IN THE UPSIDE DOWN POSITION FOR THE NEXT PART OF ASSEMBLY)
7. REPEAT ALL OF THE ABOVE STEPS FOR THE OTHER TROLLEY SIDE PANEL (PART 3 OR 4).
TROLLEY SIDE PANEL.
5. REPEAT STEPS 3 & 4 FOR THE THREE REMAINING HOLES TO COMPLETE THE ATTACHMENT OF THE
4. ATTACH 1 x 5mm DIAMETER WASHER (PART 23) AND 1 x M5 NUT (PART 18) ONTO THE SCREW. DO NOT FULLY
HOLES OF THE BARBECUE CARCASS AND THROUGH THE HOLE OF THE TROLLEY SIDE PANEL.
3. PLACE 1 x FIBRE WASHER (PART 22) ONTO 1 x M5 SCREW (PART 14). PLACE THE SCREW THROUGH ONE OF THE
HOLES OF THE BARBECUE CARCASS.
2. ALIGN THE HOLES AT ONE END OF ONE TROLLEY SIDE PANEL (PART 3 OR 4) WITH THE CORRESPONDING
1. PLACE THE BARBECUE CARCASS (PART 1) UPSIDE DOWN AS SHOWN ABOVE.
TIGHTEN AT THIS STAGE.
C
STAGE OF ASSEMBLY
IS UPSIDE DOWN FOR THIS
NOTE: THE BARBECUE CARCASS
THE SIDE BURNER HOSE
NOTE: PLEASE ENSURE THE HOLE FOR
IS TO THIS SIDE
BARBECUE
FRONT OF
1
14
14
22
22
3
4
23
23
18
18
FLINDERS, NORFOLK, DAINTREE & KIMBERLEY TROLLEY ASSEMBLY
16
To Next Page
Loading...
