EverFocus EKB500 - 6.2 COM Port Setting - RS-485 Interface; 6.3 Device Setting; 6.3.1 Camera Setting

EKB500_ma_en_rev1.5_3.doc 17
6.2 COM PORT SETTING - RS-485 INTERFACE SETTING
Define telemetry protocol type and transmission rate in this menu.
M
M
M
E
E
E
N
N
N
U
U
U
> COM PORT SETTING >
E
E
E
N
N
N
T
T
T
E
E
E
R
R
R
Select port 1 or 2 and confirm with
E
E
E
N
N
N
T
T
T
E
E
E
R
R
R
.
Use the joystick to change the value.
Selection: 1200, 2400, 4800, 9600 Baud.
Press
E
E
E
N
N
N
T
T
T
E
E
E
R
R
R
to confirm the setting and
E
E
E
S
S
S
C
C
C
to cancel.
The next menu is used for telemetry protocol
setting.
Use the
J
J
J
O
O
O
Y
Y
Y
S
S
S
T
T
T
I
I
I
C
C
C
K
K
K
to change the value.
Selection: EVF-1: V-Protect Speed Dome
EVF-2: EverFocus EPTZ series
A-Type: EverFocus ED2200/2250,
Samsung SCC-641/643/6405
Pelco-D
Pelco-P
Panasonic
L-Type LG Electronics
ATTENTION: Protocol type setting is irrelevant for EverFocus DVR control; only baud rate setting is
relevant!
Press
E
E
E
N
N
N
T
T
T
E
E
E
R
R
R
to confirm the selection and
E
E
E
S
S
S
C
C
C
to cancel.
6.3 DEVICE SETTING
Connection settings definition for controlled devices.
6.3.1 Camera setting (changed from FW 1.5)
Use this menu to define telemetry cameras and cameras to be assigned to DVR monitors. In difference to
former EKB500 firmware versions this setting is valid for Main- and Call/Matrix - Monitors.
M
M
M
E
E
E
N
N
N
U
U
U
> DEVICE SETTING > CAMERA SETTING >
E
E
E
N
N
N
T
T
T
E
E
E
R
R
R
Camera number 1 ~ 9999 (independent of RS-485 address!)
Press Enter to confirm the setting and Esc to cancel.
Protocol : EVF-1
[ ↑ ↓ ] to change
Port : 1 Changed
[ ENT ] to save
Camera Name : ___
Port : _ ( 1 or 2 )
Input the port.
BAUD : 9600 <
[ ↑ ↓ ] to change