Everglades 335 CC - Recommissioning

153
Seasonal Maintenance
CAUTION
PLACING AN ELECTRIC OR FUEL BURNING HEATING UNIT
IN THE BILGE AREA CAN BE POTENTIALLY HAZARDOUS
AND IS NOT RECOMMENDED.
Proper storage is very important to prevent serious
damage to the boat. If the boat is to be stored
indoors, make sure the building has enough ven-
tilation. It is very important that there is enough
ventilation both inside the boat and around the
boat.
Notice:
If the boat is to be stored indoors or out-
doors, open all interior drawers, clothes
lockers, cabinets and doors a little. If pos-
sible, remove the upholstery, mattresses,
clothing and rugs. Then hang a commercially
available mildew protector in the interior
compartments.
14.3 Recommissioning
WARNING
DO NOT OPERATE THE BOAT UNLESS IT IS COMPLETELY
ASSEMBLED. KEEP ALL FASTENERS TIGHT. KEEP
ADJUSTMENTS ACCORDING TO SPECIFICATIONS.
Notice:
It is important and recommended that the
tting out procedure for the marine gear be
done by a qualied service person. Read the
engine owner’s manual for the recommended
procedure.
CAUTION
BEFORE LAUNCHING THE BOAT, MAKE SURE THE HULL
DRAIN PLUG IS INSTALLED.
Reactivating The Boat After Storage:
• Charge and install the batteries.
• Install the drain plug in the hull.
• Check the engines for damage and follow the
manufacturer’s instructions for recommis-
sioning.
• Check the mounting bolts for the engines to
make sure they are tight.
• Perform all routine maintenance.
• Check all hose clamps for tightness.
• Pump the antifreeze from the fresh and raw
water systems and ush several times with
fresh water.
• Check and lubricate the steering system.
• Clean and wash the boat.
• Install all upholstery, cushions and canvas.
After Launching:
• Carefully check all water systems and the
engine bolts for leaks. Operate each system
one at a time checking for leaks and proper
operation.
• Check the bilge pump manual and automatic
switches.
• When each engine starts, check the cooling
system port below the engine cowling for a
strong stream of water. This ensures that the
cooling pump is operating.
• Carefully monitor the gauges and check for
leakage and abnormal noises.
• Operate the boat at slow speeds until the en-
gine temperature stabilizes and all systems
are operating normally.