22
Component Identification and Explanation
Rear Panel View
Number Component Identification Component Note
1 Power Switch This is used to switch the unit on and off.
2
Shielding Gas Connection
(5/8” CGA)
5/8” CGA Fitting is used in North American Markets. Other markets may use a hose barb connection.
3
Fan location Periodically check for proper fan function and cleanliness.
4
HF Ground Service Bolt** For use in a combined effort to mitigate any electrical interference that may be caused by this unit.
5
Power Cord and NEMA 5-15 Plug
(12 Gauge, 6 ft.)
This plug and cable is correctly sized for the rated amps, duty cycle and length of the cable. Consult Article 630 of the NEC for
more details.
1
2
3
5
4
To Next Page
Loading...
