31
TROUBLE CODE WITH WARNING LIGHT/UNIT
STOPS WELDING BUT IS TURNED ON.
DIAGNOSIS
01 OVER TEMPERATURE/ DUTY CYCLE EXCEEDED. Allow unit to rest for 15 minutes. Check for
obstacles, clean welder, and heat sinks. Make sure unit is unplugged for 30 minutes before opening
up for cleaning.
02 OVER CURRENT. Check to make sure input power cable is correct length and size. Internal unit
fault or low input voltage. Possible issue running on generator with dirty power. Identify cause,
plug directly into the receptacle. Cycle the switch one time. If the code does not clear, call Everlast
Tech Support.
OTHER CONTACT EVERLAST
Troubleshooting
Error Codes
To Next Page
Loading...
