34
Note: The sensor requires a 24-hour Warm-Up Phase to stabilize in
your body before glucose values will be collected by the smart transmitter.
During the Warm-Up Phase, you do not need to wear the smart transmitter.
If you decide to wear the smart transmitter over the sensor during this
time, you will receive a message on the app indicating the Warm-Up Phase
is in progress. Once the Warm-Up Phase is complete, turn ON the smart
transmitter and place it over the sensor with the Eversense adhesive patch.
The system will prompt you to calibrate using the app.
IMPORTANT: If your smart transmitter is not turned on and paired with the Eversense App and linked to the
sensor, the system is not able to prompt you to calibrate.
4
Warning: The Eversense CGM System will not provide readings
during the 24 hour Warm-Up Phase and until a second calibration is
successful during the Initialization Phase. During this time, you should
monitor their glucose using a home blood glucose monitor.
LBL-1602-01-001 Rev N_Eversense User Guide_mgdL_R1.indd 34LBL-1602-01-001 Rev N_Eversense User Guide_mgdL_R1.indd 34 2/26/20 12:58 PM2/26/20 12:58 PM
To Next Page
Loading...
