Evinox ModuSat - Annual Maintenance Inspection; Warranty Terms and Conditions

38
6.1 Annual inspection
It is recommended to carry out the following controls on the appliance at least once a year:
 The control and safety devices (sensors, thermostats, etc.) must work correctly
 The system must be watertight
 DHW flow must be regular
The system should not be emptied frequently except for modifications or repairs. In zones
subject to freezing, the system must be emptied if it remains inactive. The operation can
be avoided only by adding appropriate antifreeze. N.B.: In zones where water is
particularly hard, it is recommended to install a water softener or de-scaling device on the
cold water input in order to prevent lime scale from forming quickly.
6.2 Warranty
The warranty has value if good practice has been strictly observed for installation and use.
Evinox is not liable for equipment breakdown and damage to persons and objects caused
by:
 Transportation
 Installation in which the Standards in force and good practice were not complied
with
 Improper use of the device, abnormal use conditions, tampering by unauthorised
personnel or inadequate maintenance; therefore by: Corrosion and/or sludge
accumulation; lack of electrical energy; absence of suitable drainage; exceeding
operating pressures; electrical and water system anomalies
 Freezing or fortuitous causes
 Wear due to normal use
 Malfunctioning of control and safety parts
 Corrosion due to oxygenation or roaming currents
From commissioning, ModuSat TP appliances are guaranteed against all manufacturing
faults and material defects for a period of:
 2 years for parts and labour *
However, the ModuSat TP warranty will always start from the date of the serial number
and will be extended by a maximum of 6 months to allow for project completion. If the
ModuSat TP is commissioned before the 6 month extensions the warranty will start from
the commissioning date.
This guarantee is strictly limited to the supply, free of charge, of parts acknowledged as
being defective after inspection by our technical departments, with the exclusion of labour
and transport costs arising from this. These parts once again become the property of
Evinox and must be returned to them without delay.
Failure to comply with the relevant installation requirements of the Building Regulations,
Local Water Byelaws and Building Standards will invalidate any warranty claim.
The ModuSat TP must be fitted with an isolation valve for servicing and warranty work.
Warranty calls that include draining the system will be chargeable if isolation valves have
not been fitted.
It is imperative that the level of corrosion protector within the system is kept within industry
guidelines at all times. Special attention should be given to ensure that, after any
decoration or building works where radiators might be removed, the system is replenished
with chemicals. Non-use of inhibitor will invalidate the warranty.
We will register the warranty when we commission the boiler and ModuSat TP units.