8
Under no circumstances should you connect the USB data cable before the installation of the printer driver is complete.
To save energy, the printer will automatically switch itself to standby mode after 10 minutes of inactivity. It will switch to sleep mode
after 30 minutes in standby mode.
The standby times can be set up in the Edikio Print Center. In standby mode, sending a print request restarts the printer, and briefly
pressing the control button (for 1 second) takes the printer out of sleep mode.
Before attempting any maintenance, always ensure that the power cable is unplugged. For your personal safety, ensure that the
cable and power supply unit can be easily accessed, especially in the event of an emergency.
Please refer to the section on printer driver installation in this chapter for further details, and follow the instructions carefully.
Connecting the USB cable
To Next Page
Loading...
Need help?
General
