7
INSTALLATION
Connecting the printer
Connection to the power supply
∙
Remove the sticker that covers the connection ports at the back of the printer.
∙ Connect the power cable to the power supply unit, then plug the power cable jack into the printer.
∙ Next, plug the end of the power cable into a grounded power socket.
∙ The printer is powered on: the control panel lights up showing that the printer is working
properly. If the control panel does not light up, then either the installation has not been carried
out correctly or the printer is not working properly. Check the installation.
!
The printer must be connected to a properly protected and grounded electrical installation.
FI: Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan.
NO: Apparatet må tilkoples jordet stikkontakt.
SE: Apparaten skall anslutas till jordat uttag.
DK: Printeren skal tilsluttes til en korrekt beskyttet og jordforbundet el-installtion.
The Edikio Access printer must be placed in a dry location, protected from dust and drafts, and well-ventilated. Please ensure you
keep your printer on a flat, strong surface able to bear its weight.
NOTE
To Next Page
Loading...
Need help?
General
