Connect the cables:
• Connect the propulsion cable (8-pin connector) and the (optional) side-scan sonar cable (3-pin connector) to the
corresponding sockets (1 in Fig.6) on the main body. Fasten the connector screws.
Figure 6: Sonobot assembly
1 - Connectors; 2 - Main body latches; 3 - WLAN antenna; 4 - On/Off switch
Close the unused sockets on the main body with the attached screw caps. Make sure you tighten the waterproof
caps to avoid leakage.
• Make sure the eccentric latches (2 in Fig.6) on the main body are fastened tight enough to avoid leakage into the
main body of the vehicle.
8
To Next Page
Loading...