/39
POWER SAVE FUNCTION
SMART START
SLEEP MODE
To maximise the battery run time for your remote, tilt at a low angle and
the Power Save function will turn the remote screen off. Power Save will
automatically activate one minute after the remote is turned ON.
When the rider lifts the remote to a more level position, it will turn back ON.
To deactivate/reactivate this function, go into the ‘Options’ section of the
remote menu and change the settings for ‘Power Save’.
When your Evolve Skateboard is turned on it has the ability to enter an
inactive state (Sleep Mode) that can be remotely turned on by your Phaze
remote.
After 5 minutes of no use, your board and Phaze remote will enter Sleep
Mode to save on battery life. While in this mode no controls will function.
To start your board and remote, press the brake trigger. If lights are
connected they will ash and you are ready to ride.
When your board has not been used for 5 consecutive minutes, it will
automatically enter Sleep Mode to conserve power and prevent unintended
operation.
Your board is able to stay in Sleep Mode for up to 3 hours. At 3 hours the
board will power off. Smart Start function will not be availble and the board
will need to be turned off and then back on through the ON/OFF button.
NOTE : When you reactivate your board it will be in SAFE mode. To exit
the SAFE Mode function, press the Mode 1 button to return the previous
speed setting you were riding.
To Next Page
Loading...