/44
If you experience symptoms such as difculty changing Speed Modes, you
are unable to turn the remote off before the board or you can brake but not
accelerate, this is usually caused by movement of the trigger magnets from
their original positions within the remote case.
In most cases, the Phaze remote will detect this automatically and prompt
you to perform a trigger calibration.
1. Ensure the skateboard is turned off. Press the ON/OFF BUTTON on the
remote.
2. From the default screen ‘Pair Remote’ screen, double click the ON/OFF
BUTTON to access the menu.
3. Scroll by pressing the MODE BUTTONS to ‘Trigger Setup’ and press the
ON/OFF BUTTON to conrm selection.
4. Follow to on screen prompts to calibrate the triggers.
5. The remote will now be in the pairing screen.
TRIGGER CALIBRATION
ALWAYS ensure the skateboard is turned off before performing a
trigger calibration.
Do not attempt to perform a trigger calibration while riding or
standing on the board.
To Next Page
Loading...