/48
CHARGING SAFETY
• Do not leave your battery unattended while charging.
• Always allow board to cool for 30 minutes before charging. Do not connect
your board to the charger until the battery pack has had a chance to cool to
an allowable charging temperature.
• Only charge the battery indoors in dry spaces that are not excessively hot or
cold (within 12°Celsius / 53.6°F of room temperature).
• Ensure there is no dirt, debris or flammable items nearby when using the
charger.
• The charger will automatically stop charging once the battery reaches its full
capacity.
• The light on the charger will be red when the battery is charging and will turn
green when charging has finished.
• Avoid leaving the charger plugged into the board when the battery is fully
charged.
• Do not charge the battery if you notice the battery is damaged, excessively
hot, leaking, smells, or is discoloured.
• Charging the battery should take approximately 3.5 - 4 hours if the battery is
mostly empty.
• Only grab the charger by the plug and not the cable when plugging and
unplugging from the wall.
• Store your board indoors in a dry space, away from heat or flame sources
and out of direct sunlight.
• The charger may get hot, up to 74°Celsius (>165°F) when charging. Use
caution and avoid touching the body of the charger.
• Only charge your Skateboard with its dedicated charger. Use with other
types of batteries may burst causing personal injury and damage. The
battery pack voltage must match the battery pack charging voltage of the
charger. Otherwise, there is risk of fire and explosion.
• Do not expose the charger to rain or wet conditions. If water enters a
charger, there is a risk of electric shock.
• Only use the original Skateboard's battery charger supplied with your board.
Bypassing the battery charger or the use of a non-approved battery charger
can lead to death or serious injury.
• Keep battery charger clean. Contamination can lead to the risk of an electric
To Next Page
Loading...