TAKE
This key corresponds to the ‘Trig/Stop Rec’ command on hypermotion cameras.
With a single-block memory or when the last block is reached, press TAKE to stop the
recording.
With a multiple-block memory, pressing TAKE induces the following actions:
• The recording stops on the current block.
• The material on the current block is loaded on the camera in play mode.
• The recording starts on the next empty block, if available. If no empty block is left, the
recording stops.
Lever
There is no corresponding command on hypermotion cameras.
Press the Lever key to shift to the secondary lever range (defined in the 2nd Lever
parameter in the hypermotion secondary menu) for material played out using the
hypermotion feature.
CAM Keys
When you press a CAM key corresponding to a recorded block, this loads the last
recorded frame of the selected block in play mode.
When you press a CAM key corresponding to a block in REC, this loads the last recorded
frame of the selected block in play mode, and the recording starts on the next empty
block, if available.
When you press a CAM key corresponding to an empty block, the remote beeps.
CLEAR
Press the CLEAR key to clear the recorded material on a block. It can be used in the
following ways:
• To clear the record on a given block that is not in PLAY mode, press CLEAR and the
CAM key corresponding to the requested block.
• To clear the record on a block when the block is in PLAY mode, press CLEAR. The
PLAY is stopped, the recorded material is deleted from the block, and the camera
automatically starts recording again in this block if it is not recording on any other
block yet.
Note
The CLEAR button is only active on some cameras.
10 3. Operation
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
