3.2.3. Creating a Clip from a Hypermotion Camera
When the camera is replaying its content into the EVS server, you can clip it automatically
directly from the remote controlling the camera.
Use the IN and OUT keys and the F_ keys to clip the record train corresponding to the
hypermotion camera and to store it at a clip position. So you can clip the hypermotion
camera without having the control on a PGM, and without having to wait for all the content
to be recorded on the server.
Once you have played back the material recorded in the hypermotion camera, it is
available in the record train of the camera as defined in the Recorder setting (p6.4, F2).
You can now create clips with this material.
To do this, proceed as follows:
1. Come back to the LSM mode with SHIFT+D (with remote in hypermotion+LSM mode)
or use another remote (with remote in hypermotion only mode).
2. Load the relevant record train on the PGM.
3. Jog in the material and add a MARK IN, MARK OUT as usual to create the requested
clip.
3.2.4. Managing Cue Points
When the controller controls the camera, press Mark to define and set up to 255 cue
points. You can add the cue points on the current block in record mode.
When the Cues parameter is set to On, you can press the Last Cue key to call back the
cue points. As cue points are managed by block, select first the requested block to be
able to recall the cue points defined in this block.
Refer to the following topics for more information on cue point management:
• "LCD Menu on the Remote Panel" on page 11
• "Key Commands on the Remote Panel" on page 8
• Specific features of each camera model for more information on cue point
management.
USER MANUAL Multicam LSM 12.05 Hypermotion Cameras
3. Operation 13
To Next Page
Loading...
Need help?
General
