3.3.3. FOR-A FT-One Camera
Application Start
At application start, when the block numbers has been selected, the camera automatically
starts recording on the first memory block.
Parameter Values
The tables below list the parameter value, or value range that are specific to the camera.
The configuration parameters are defined in the Multicam Configuration window,
Operation page, Hypermotion controller section.
Configuration Parameter Value
Port Ethernet
Protocol UDP
The operational parameters are defined in the Hypermotion mode of the Remote Panel, in
the LCD secondary menu.
Operational Parameter Value Range Default Value
# Blocks 1 to 4 1
Pre-Roll from 00s00fr to 5s00fr 00s00fr
PGMSpeed 50, 100, 200, 400, 800, 1600% 100
2nd Lever +/- 1600%, 0-1600% +/- 1000
Specific Behavior of Remote Panel Keys
• RECORD: Pressing this key when no block is in RECORD and no block is selected
starts recording on the first block. Previously recorded material remains unchanged.
• RECORD: Pressing this key while the current block is recording clears all memory
blocks in play or recorded state. The material on the current recording block is not
deleted. It is moved to the first block, and the camera starts recording on the next
empty block (block 2).
• RECORD: The Remote beeps if the CAM key refers to an empty block.
• TAKE: This key is operational in REC STANDBY mode. When the user presses the
TAKE key, if a block was in play mode, it remains in this mode. If no block was in play
mode, the previous recording block starts playing.
• CLEAR (+CAM key): Pressing the CLEAR key deletes the data on the memory
block that is in PLAY (or on the selected block) and shifts the recording block to the
left.
22 3. Operation
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
