3.3.2. FOR-A VFC-7000 Camera
Application Start
At application start, the recording starts on the first memory block.
Parameter Values
The tables below list the parameter value, or value range that are specific to the camera.
The configuration parameters are defined in the Multicam Configuration window,
Operation page, Hypermotion controller section.
Configuration Parameter Value
Port Ethernet
Protocol UDP
The operational parameters are defined in the Hypermotion mode of the Remote Panel, in
the LCD secondary menu.
Operational Parameter Value Range Default Value
# Blocks 1 to 4 1
Pre-Roll from 00s00fr to 5s00fr 00s00fr
PGMSpeed 50, 100, 200, 400% 100
2nd Lever +/- 1000%, 0-1000% +/- 1000
Specific Behavior of Remote Panel Keys
• RECORD: Pressing this key while the current block is recording clears all memory
blocks and starts recording on the first one.
• RECORD: The Remote beeps if the CAM key refers to an empty block.
• TAKE: This key is operational in ARM mode.
• CLEAR: Pressing this key deletes the current memory block data.
20 3. Operation
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
