Speedbreak Parameter
When the Speedbreak functionality is available, it will be displayed as illustrated.
Press the corresponding key to activate (highlighted) or deactivate it (normal display).
Off Ramp UP SpeedBrk LSM Mode
Block 1 Block 2
See section "Using Speedbreak" on page 17
Note
Currently, the Speedbreak functionality is available only for Vision Research
and NAC Hi-MotionII cameras.
Hypermotion Secondary Menu
From the hypermotion main menu, press the MENU key to open the hypermotion
secondary menu illustrated hereunder.
# Blocks Pre-Roll PGMSpeed 2ndLever
2 00s10fr 50% +- 1000
This secondary menu includes the hypermotion settings described in the table below. To
modify a setting, press the corresponding softkey and jog to select the requested value.
The default setting value is specified in the table. As the value range often vary from one
to the other camera, the available values are listed in the camera-specific chapter. See
section "Specific Camera Features" on page 19.
Setting Description
#Blocks Number of memory blocks of the hypermotion camera to be used, if the
connected camera supports this feature.
The number of blocks displayed in the main menu depends on the
number of blocks specified in this parameter. 1 to 4 memory blocks can
be used (default: 1).
Pre-Roll Length of the preroll for the cue points defined on the material recorded
from the hypermotion camera.
The Last Cue command will go to the desired TC - preroll if the material
is available. If not, the preroll is not applied.
PGMSpeed PGM speed that is to be applied for playing back material recorded on
the hypermotion camera using the SHIFT+PLAY keys.
2ndLever Secondary lever range to be applied for playing back material recorded
on the hypermotion camera.
12 3. Operation
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
