3. Jog in the sequence and define an IN point (compulsory) and an OUT point (optional)
with the IN and OUT keys.
If required, delete these points using the CLEAR + IN/OUT keys.
4. Start the replay using the PLAY button or the lever.
◦ If a speed is defined on the Remote Panel, the replay starts at this defined speed.
◦ If not, the replay starts at PGMSpeed.
The replay in Speedbreak mode is thus performed at the following speed
• Before the IN point: speed defined on the Remote Panel or PGMSpeed.
• Between the IN and the OUT points: nominal speed.
• After the OUT point: speed defined on the Remote Panel or PGMSpeed.
Managing IN and OUT Points
When the Speedbreak functionality is active:
• IN and OUT points are displayed on the OSD of the hypermotion recorder.
• IN and OUT points are memorized per block.
• IN and OUT points are deleted when:
◦ A block is recorded again.
◦ The number of blocks is modified.
◦ The configured connection type or port is modified.
◦ Multicam is restarted.
18 3. Operation
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
