Specific Behavior of Remote Panel Keys
• RECORD: The Remote beeps if the CAM key refers to an empty block.
• RECORD: Pressing this key while the current block is recording does not send any
command to the camera.
• TAKE: This key is operational in ARM mode.
• CLEAR: Press this key to delete the current memory block data.
• CAM key: When the CAM key is pressed for the first time after selecting the number
of blocks you want to work with, the block is loaded at the frame specified in the
camera menu. When the CAM key is pressed subsequently, the block is loaded at the
last frame it was last loaded on.
• ENTER + CAM key: Locks the corresponding memory block.
TAKE Key Behavior
Depending on the operational mode of the Hi-Motion II camera, the TAKE key will behave
differently, as explained below:
• In Continuous mode, when the TAKE key is pressed, the record stops on the current
block and starts on the next free block. Pressing TAKE on the last block stops the
recording. This corresponds to the standard behavior.
• In Loop mode, when the TAKE key is pressed, the record stops on the current block
and starts on the next free block. When the TAKE key is pressed on the last block,
the recording starts again on the first block.
• In Single mode, when the TAKE key is pressed, the record stops on the current
block. No record is started on another block.
Cue Points Management
• When a new ARM/REC command is issued on a block, all its cue points are cleared.
• If the Last Cue command cannot access the desired TC preroll, the player remains on
the current cue point.
• If the Last Cue command refers to a TC that does not exist anymore, the player
jumps to the beginning of the current memory block.
USER MANUAL Multicam LSM 12.05 Hypermotion Cameras
3. Operation 27
To Next Page
Loading...
Need help?
General
