Need help?Do you have a question about the EWS OS 3030 and is the answer not in the manual?
General| Brand | EWS |
|---|---|
| Model | OS 3030 |
| Category | Controller |
| Language | English |
Details conductivity measurement capabilities and ranges.
Procedure to manually start the production phase using the ON button.
Process for cancelling alarms and their associated actions.
Details alarms for minimum and maximum conductivity limits.
Describes exceeded pressure and motor circuit-breaker alarms.
Details the low-pressure alarms (1, 2, and 3) and their behavior.
Describes the concentrate signal alarms (1, 2, and 3) and their effects.
Alarms for rinse permeate and external alarm switch signals.
Alarms for tank status, power failure, and stop signals.
Configuration for dosing and permeate valve operations.
Configuration for excess pressure, low-pressure, and concentrate inputs.
Guidelines for setting up and modifying controller parameters.
Configuration of conductivity meter parameters and limits.
Adjusting conductivity readings based on water temperature.
Applying correction factors for accurate conductivity measurement.
Choosing the function for Input 1.
Choosing the function for Input 2.
Setting parameters for reservoir level switch inputs.
Configuring parameters for concentrate flow monitoring.
Setting parameters for low-water pressure alarms and restarts.
Configuring parameters for the external alarm switch.
Defining behavior and phases for the stop input.
Configuring system behavior during and after power failures.
Assigning functions to OUT1 and OUT2 relay outputs.
Setting the duration and timing for dosing pulses.
Configuring ON and OFF times for pulsed dosing.
Setting conductivity limits and delays for the permeate valve.
Defining events that trigger the alarm relay.
Setting events to trigger buzzer signals.
Setting the duration for production phase stages.
Defining valve states and output activation for production stages.
Defining the system phase when a fault occurs.
To Next Page
