Internal Value Mode
(
must hook up full-bridge Load Cell to test)
Pres key and display shows internal value
Please check the internal value is within range
Check whether the backlight is on
Press key to back to last screen, the display shows
Keypad Test Mode
Press key to enter, display shows
Keypad’s internal cod: = 04, =05, =07, =06, = 03
Press key to back to last screen, the display shows
Firmware Version Display Mode
Press key to enter, display shows the firmware version
Press key again, the display shows maintenance number for 2 seconds
Press key to back to the last screen, display shows
Back to the Last Screen
Press key, exit self-test mode, the scale will reboot automatically.
2-5 Self-Test Mode
When power is off, hold key and press key to
wait till display shows 01 AdC to
enter “Self-Test Mode”
Counts averaging setting
Press key to select 1, 2, 4, 8, 16, 32, 64
Press key to confirm. Default setting = 8
Error range setting (1%~100%)
Press key to adjust; Press key to confirm
Press or key to move cursor
Default setting = 10%
To Next Page
Loading...
Need help?
General
