Chapter 3 Further Function Setting
3-1 Enter Function Setting
Power on the scale and before the scale counts down to zero, press key first. And
then press keys in order and within 10 seconds to enter Function setting.
If you press the wrong key, please press key again and press three keys in order
before entering weighing mode.
3-2 Function Setting
Switch the switch SWA1 back to the LOCK position for approval models, while switch
the switch SWA1 to the ADJ position for non-approval models.
Press key to select function. After selection, press key to enter the setting.
To Next Page
Loading...
Need help?
General
