52
function disable, the system treat all C.O. line as normal trunk line.
Format： 0710#
Description: Routing function enable and In Auto-select the least-cost
routing model
Format: 0711#
Description: Routing function disable, also cancel the system In
Auto-select the least-cost routing model
Format: 0720#
Description: Routing function enable and the system In Manual-select the
least-cost routing model
Format: 0721#
Description: Routing function disable, also cancel the system In
Manual-select the least-cost routing model
Format: 0730#
Description: The system will go to the normal trunk line if the special trunk
line is busy.
Format: 0731#
Description: Don’t allow the system use the normal trunk line if the special
trunk line is busy.
Format: 0732#
Description: The system will go to the special trunk line if the normal trunk
line is busy.
Format: 0733#
Description: Don’t allow the system use the special trunk line if the normal
trunk line is busy.
Format: 0740#
Description: allow the normal trunk line outgoing & incoming.
Format: 0741#
Description: Don’t allow the normal trunk line outgoing.
Format: 0750#
Description: allow the special trunk line outgoing & incoming
Format: 0751#
Description: Don’t allow the special trunk line outgoing.
Setting the trunk line to Normal trunk line / Special trunk line
Format: 0760#
Description: all trunk lines are set as the Normal trunk line
Format: 076M#
Description: The trunk lines NO.M is set as the Normal trunk line (M=1-3)
Format: 0770#
Description: all trunk lines are set as the Special trunk line
Format: 077M#
Description: The trunk lines NO.M is set as the Special trunk line(M=1-3).
Setting outgoing access-code for Special trunk line
Format: 078K#
Description: In Manual-select the least-cost routing model, setting
outgoing access-code K for Special trunk line.
To Next Page
Loading...
