EXE RISE D8 - Figure 33 Removing the Frame Block

48 / 64
4) Remove the lifting hook.
5) Remove Aluminum Frame Block (see figure 34).
Figure 33: “Removing the Frame Block”
6) Feed the lifting chain through the new lift hooks pulley. Make sure the chain is not twisted (see
figure 35).
Figure 34: “Replacement of the Chain hook”
7) Re-connect the chain to the aluminum frame block (see figure 36).
Figure 35: “Re-applying of the frame block”
8) Run the chain minimum 2 meter through the lift hook to ensure good operation.