Operating Your Chromatic Dispersion Analyzer
26 FTB-5800
Selecting the Source Type
Selecting the Source Type
Different sources can be used for testing with your Chromatic Dispersion
Analyzer. The different sources allow you work on either the C-band, the
L-band or the C+L-bands.
Note: If you change the source type, you must perform a new reference
measurement. For details, see Performing Reference Measurements on
page 28.
To select the source type:
On the Parameters tab, select the desired source in the corresponding list.
Source Type Available Bands
FLS-5834, FLS-5804, FLS-5803 C, L, C+L
FLS-5834A C+L
To Next Page
Loading...
