SAIC Exploranium – GR-135 System Manual page: 41
c) BACKLITE – sets the display Backlite operating mode. Selections are OFF, ON, 5S, 10S, 30S, 60S.
OFF – means that the Backlite will only be switched ON when the user powers on the unit by
holding the joystick down for 4 seconds. If this is done the Backlite will come on and stay on
until the unit is powered off.
ON - means that the Backlite is switched ON permanently until the selection is changed. With this
setting when the unit is power on the Backlite will come on and stay on
5S(10—60S) – means that the Backlite will come on and stay on for 5 seconds then go off.
However every time the joystick is activated it will come on again for 5 seconds
Backlite use reduces battery life by 50% so is only recommended when essential.
d) ACTIVE LIBR – this sets the Library used for analysis – selections are
STAND (Standard),
MEDIC (Medical), INDUST (Industrial), WASTE (Waste sites) or USER. These libraries have been
selected as optimum for the different applications. However some users have special requirements
and require a special library. In this release of software, all special libraries must be constructed by
Exploranium (send request to hovgaardJ@SAIC.com
or komarI@SAIC.com) as required. These new
libraries are then loaded into the USER location using the Exploranium supplied PC support program
IdentiView (see Appendix B for more details). A new release of PC support software currently
scheduled for Jan 2003 will provide a “LIBRARY BUILD” program so users can construct their own
libraries.
Note that once selected in this parameter setting, the actual isotopes in the library can be viewed in
MAINTENANCE/LIBRARY as described below.
To Next Page
Loading...