SAIC Exploranium – GR-135 System Manual page: 43
11.5 DEFAULTS
This selection permits the user to LOAD DEFAULT PARAMETERS.
This is sometimes useful when the instrument has not been used for
a long period or when “strange” system performance occurs.
Like all computer-based systems, sometimes the data memory gets
corrupted. The system software checks all functions continuously to
try to trap any problems that could cause memory corruption but not
all features can be protected against.
For these reasons sometimes it is necessary to clean the entire
system memory and load the basic Default parameters.
Fig. 39
This is done by selecting this function and a new figure appears
NOTE – LOADING DEFAULT PARAMETERS ERASES ALL DATA
MEMORY SO IF NECESSARY THE USER SHOULD SAVE THE DATA
USING IdentiView BEFORE LOADING DEFAULTS
.
As the display shows, press ENTER 3 times to activate this feature.
The screen then shows the figure on the right. The unit will return
to the Maintenance screen when defaults have been loaded.
Fig. 40
11.5 ADC TEST
This special feature is used during system setup
IT IS NOT RECOMMENDED FOR GENERAL USE
AS IT CONTAINS NO USEFUL INFORMATION
FOR THE NORMAL USER.
Fig. 41
MAINTENANCE
PUSH ENTER THREE TIMES
TO LOAD DEFAULT
OR UP ONCE
TO EXIT
MAINTENANCE
DEFAULT LOAD ROUTINE
ENGAGED
WAIT UNTIL FINISHED
ADC TEST
CH 15 CNT 1
CH 28 CNT 1
CH 30 CNT 1
CH 34 CNT 1
CH 40 CNT 1
CH 47 CNT 1
MAX 48 CNT4
F GAIN 512
TOT.COUNT 32
GM-DET 0 NEV 0.000
LIVE TIME 949
COSMIC 1
CONTRAST 32
TEMP 25 27 24 VOLT 241
PILEUP 0
To Next Page
Loading...