Extra 300/SC - Page 140

CHAPTER 20
PAGE 20
MAINTENANCE MANUAL EXTRA 300/SC
PAGE DATE: 1. August 2014
18 Remove tail weight.
19 Check if all switches are in Off-position and connect bat-
tery.
22 Perform operational check of electrical equipment.
21 Inspect trim tab for full travel and deflection in relation to
the trim indication.
22 Shut-off master switch after completion.
23 Perform operational check and rigging of control system.
24 Inspect fluid filled lines for leaks.
25 Check security of main spar bolts.
26 Install wheel fairings, main fuselage cover and rear support
angle, canopy, engine cowlings, and access panels (Refer to
Chapter 51-00-01 and 53).
27 Check all control surfaces for freedom of movement and
security.
28 Perform a compass compensation according to „Aircraft
Inspection and Repair FAA AC 43.13“.
29 Check correct servicing of aircraft.
30 Perform an engine run up. Refer to Chapter "05-20-04
Maintenance Checks Schedule". Start the engine in accord-
ance with the Pilot’s Operating Handbook and Airplane Flight
Manual (POH).
31 Inspect aircraft for foreign objects.
32 Final inspection by licensed aircraft inspector.
I M P O R T A N T After first flight check fuselage interior/exterior for
fuel leaks. Check all bolts on fairings and cover sheets
for tight fit.
ASSEMBLY INSTRUCTION
Assembly Instruction after Container Shipping