CHAPTER 51
PAGE 33
MAINTENANCE MANUAL EXTRA 300/SC
PAGE DATE: 1. August 2014
N O T E The Rapid Filler must be completely dry before the cov-
ering paint can be applied.
For the final sanding, use 400 grade wet sandpaper to achieve
a smooth clean surface. Allow surface to dry. Paint applica-
tion of Glassodur-Pur-Acryl-Lack AD/AE 21 two compo-
nent acryl paint is performed with a spray gun.
Paint can be mixed with small quantities of reducer. After
completion of the painting, polish the repair area.
51-70-08 Aluminium and Steel Components
Refinishing
Complete procedure necessary to remove existing paint
from aluminium and steel components and then to repaint
them as described in the following paragraphs.
Degreasing
W A R N I N G Cleaning solvents can be toxic and volatile. Use only in
well ventilated areas. Avoid physical contact with sol-
vent and do not inhale vapors. Keep solvent containers
covered when not in use.
N O T I C E Before stripping parts, remove all fittings, O-rings,
nuts, bolts, washers, pistons, bearingcups, etc.
1 Clean all metal parts by immersing in a clean degreasing
solution. An alkaline based solution is recommended for
aluminium and magnesium parts.
2 Hardened dirt or grease may be removed with soft bristle
brush, or by soaking in cleaning solution.
3 Where necessary clean bearing cones carefully in a sepa-
rate container of clean solvent.
N O T I C E Do not spin bearing cones with compressed air.
REPAIRS
To Next Page
Loading...
