CHAPTER 51
PAGE 35
MAINTENANCE MANUAL EXTRA 300/SC
PAGE DATE: 1. August 2014
5 Where applicable refer to inspections procedures given in
the respective chapters for specific parts to locate possible
defects.
N O T E Refinishing should be completed as soon as possible;
unprotected parts will begin to corrode.
Repainting
Paint all surfaces exept those which are subjected to friction
(bearing surfaces, anchor bolt bores, etc.). Proceed as fol-
lows:
1 Parts to be repainted should be cleaned and stripped per in-
struction in degreasing and paint removal paragraphs.
2 Aluminium parts should have a protective barrier between
the topcoat and base metal. It is recommended they be treated
with solutions listed in Chapter 51-30.
3 Apply solution liberally and evenly. Allows it to set from 1
to 5 minutes. The solution must completely wet the surface
and overlap onto the adjoining anodize.
4 Remove excess coating by flushing with clean water.
5 Paints parts with one coat of wash primer. Allow to dry thor-
oughly.
6 Paint parts with one coat of lacquer listed in Chapter 51-30.
Allow to dry thoroughly before reassembly.
Aluminium and Steel Components Refinishing
REPAIRS
To Next Page
Loading...
