CHAPTER 61
PAGE 8
MAINTENANCE MANUAL EXTRA 300/SC
PAGE DATE: 1. August 2014
mm [1/32"]) is ensured at the rpm control knob (see figure
2).
3 Check full travel.
4 If necessary adjust rod end (1, figure 2) by the following
steps:
a Remove cotter pin, castle nut, washers and bolt from the
rod end (1) to governor control lever (2) attachment.
b Loosen the counter nut and adjust rod end (1) by turning.
Ensure thread is visible in the inspection hole when fasten-
ing. Apply inspection lacquer on the counter nut.
c Reconnect the rod end (1) to the governor control lever (2).
To Next Page
Loading...
