CHAPTER 73
PAGE 7
MAINTENANCE MANUAL EXTRA 300SC
PAGE DATE: 1. August 2014
N O T E It is essential that the rod end is screwed onto the
threaded terminal until the inspection hole of the rod
end is completely filled with thread (mimimum
8 turns).
13 Screw the rod end onto the threaded terminal.
14 Tighten the counternut to prevent rod end from loosening.
15 Install the rod end to the throttle control lever with bolt,
washers, castle nut and cotter pin (3, Figure 3). Tighten the
castle nut slightly.
17 Ensure movability of throttle control lever.
18 Perform Throttle Control Lever Rigging (refer to Chapter
73-20-12.
Perform the following steps on the throttle control lever
side of the control cable, if there are throttle control lever
travel stops:
12 Place a 0.5 mm washer under the rear travel stop bolt (7,
Figure 3) of the throttle control lever.
13 Tighten the rear travel stop bolt.
14 Hold a 1.5 mm shim between the rear travel stop (6, Figure 3)
and the rear travel stop bolt (7, Figure 3) and place the throttle
control lever to full idle travel stop position.
N O T E It is essential that the rod end is screwed onto the
threaded terminal until the inspection hole of the rod
end is completely filled with thread (mimimum
8 turns).
15 Screw the rod end onto the threaded terminal to match this
throttle control lever position.
14 Tighten the counternut to prevent rod end from loosening.
16 Install the rod end to the throttle control lever with bolt,
washers, castle nut and cotter pin (3, Figure 3). Tighten the
castle nut slightly. Ensure movability of throttle control le-
ver.
17 Push the throttle control lever forward. Check throttle ac-
tuator is at the WOT travel stop position.
18 Install washers at the front travel stop bolt (8, Figure 3) so
that a gap of 1.5 mm results between front travel stop bolt
To Next Page
Loading...
