Extra 300/SC - Page 75

MAINTENANCE MANUAL EXTRA 300/SC
CHAPTER 05
PAGE 37
PAGE DATE: 1. August 2014
Landing gear
O 1 Examine landing gear mounting clamps for defects (e.g. cracks and
deformed areas).
O 2 Check clamp bolts of the landing gear for cracks, replace when
necessary.
O 3 Examine wheel track and check if measurement correspond to the
value given in Chapter 06-10-01.
O 4 Remove and check the fairings for delamination, deformations and
cracks.
O 5 Check the landing gear spring for delamination, deformations and
cracks, especially in the area of the axle attachment.
O 6 Check fuselage structure in the area of landing gear attachment for
deformation and cracks.
O 7 Examine wheel base and check if measurement correspond to the value
given in Chapter 06-10-01.
O 8 Check tires for cuts in the side wall.
O 9 Check wheel halves and brake discs for impacts, cracks and distortion
according to CLEVELAND instruction.
O 10 Check tail wheel for deformation and cracks, especially in the area of
the axle attachment.
O 11 Check fuselage structure in the area of the tail wheel for deformation
and cracks.
Control surfaces
O 12 Check control surfaces for proper operation.
O 13 Check control surface hinges for cracks, security and free movement.
O 14 Check the balance weights of the elevator for security of attachment.
O 15 Check the spades for security of attachment.
Engine
O 1 Check engine mount.
Inspector:
Mechanic:
Inspections
Date:
Serial No.:
Hard Landing
UNSCHEDULED MAINTENANCE CHECKS