Installing a Summit X480 Series Switch
Summit Family Switches Hardware Installation Guide
261
5 At the front of the switch, place a front mounting bracket against each side of the switch, in front of
the ventilation openings in the side of the switch (Figure 204)
Figure 204: Positioning the Front Mounting Brackets
6 Using the provided screws, attach each front bracket to the switch (Figure 204).
7 Slide the switch back in the rack until the front mounting brackets are against the front of the rack
post (Figure 205).
Figure 205: Securing the Front Mounting Brackets to the Rack
8 Using mounting screws suitable for your equipment rack, secure the mounting brackets to the front
of the rack post.
After the switch is secured to the rack, install and connect power supplies as described on page 265 for
AC power supplies or on page 268 for DC power supplies.
NOTE
If you are installing a VIM2 module, install it in the switch before you connect the switch to power
(see page 336).
SH_129
SH_130
To Next Page
Loading...
