Chapter 1: Summit Family Switches
Summit Family Switches Hardware Installation Guide
32
Summit X250e-24p Switch
The front panel of the Summit X250e-24p switch (Figure 11) includes:
● Twenty-four fixed autosensing 10/100BASE-T PoE ports (ports 1–24). In addition to 2.4 Gbps of
high-density copper connectivity, these ports also provide a full 15.4 Watts of PoE per port.
● Two combination ports (ports 25–26) using RJ-45 connectors and SFPs to provide 2 Gbps of copper
or fiber connectivity
For more information about combination ports, see “Combination Ports and Failover” on page 22.
For information about SFPs, see the Extreme Networks Pluggable Interface Modules Installation Guide.
● LEDs to indicate port status and switch operating conditions
For a description of the LEDs and their operation, see “Summit X250e Series Switch LEDs” on
page 42.
● Stack number indicator showing the position of this switch in a stacked configuration
● Serial console port used to connect a terminal and perform local management
Figure 11: Summit X250e-24p Switch Front Panel
The rear panel of the Summit X250e-24p switch (Figure 12) includes:
● Ethernet management port with associated LEDs
● Two high-performance stacking ports with associated LEDs
● Redundant power input connector for use with the EPS-500 External Power Supply
(Model No. 10911) with full PoE power support
The connecting redundant power supply cable is shipped with the EPS-500 unit. See “EPS-500
External Power Supply Unit” on page 142 for more information.
● AC power input socket
The internal AC power supply operates from 100 VAC to 240 VAC.
1
2
Stack
SH_040B
10/100 Mbps ports
Console
port
Combination portsStack number indicator
To Next Page
Loading...
