Extreme Networks Summit X440 Series - Summit X440-24 X-10 G Switch

Chapter 1: Summit Family Switches
Summit Family Switches Hardware Installation Guide
68
Summit X440-24x-10G Switch
The front panel of the Summit X440-24x-10G switch (Figure 43) includes:
● 24 unpopulated SFP ports (ports 1–24) that provide 24 Gbps of fiber connectivity. The SFP ports
support both 100BASE-FX and 1000BASE-X optical modules.
Ports 21 through 24 are implemented as shared ports that pair a copper port with a fiber port. For
more information about combination ports, see “Combination Ports and Failover” on page 22.
For information about SFPs, see the Extreme Networks Pluggable Interface Modules Installation Guide.
● Four autosensing 10/100/1000BASE-T ports (ports 21–24) that provide 4 Gbps of high-density
copper connectivity.
These ports are implemented as shared ports that pair a copper port with a fiber port. For more
information about combination ports, see “Combination Ports and Failover” on page 22.
● Two unpopulated SFP+ ports (ports 25 and 26) that provide 20 Gbps of fiber connectivity
● Ethernet management port
● Serial console port implemented as an RJ-45 connector, used to connect a terminal and perform local
management
● LEDs to indicate port status and switch operating conditions
For a description of the LEDs and their operation, see “Summit X440 Series Switch LEDs” on
page 77.
Figure 47: Summit X440-24x-10G Switch Front Panel
The rear panel of the Summit X440-24x-10G switch (Figure 44) includes:
● Redundant power input connector for optional connection to the EPS-C2 External Power Module
The connecting redundant power supply cable is shipped with the power module unit. See
“Installing an EPS-C2 Chassis” on page 322 for more information.
● AC power input socket
The internal AC power supply operates from 100 VAC to 240 VAC.
4
5
21
7
6
3
x
1 = Ethernet management port
2 = SFP ports
3 = 10/100/1000BASE-T ports
4 = Stack number indicator
5 = Console port
6 = Combination ports
7 = SFP+ ports