Extreme Networks Summit X440 Series - Installing the Switch in a Cabinet or Four-Post Rack

Installing a Summit X650 Series Switch
Summit Family Switches Hardware Installation Guide
279
Installing the Switch in a Cabinet or Four-Post Rack
To install the switch in a cabinet or four-post rack:
1 At the back of the cabinet, attach a rear mounting bracket to each rear post, as shown in Figure 226
Figure 226: Attaching Rear Mounting Brackets—Cabinet Installation
2 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
3 Set the switch on a secure work surface.
4 At the front of the switch, attach a rack-mounting bracket to each side (Figure 227).
Position the bracket with the flange at the front edge of the switch.
Figure 227: Attaching the Front Mounting Brackets—Cabinet Installation
SH_102
SH_078