Extreme Networks Summit X440 Series - Removing a Switch from a Four-Post Rack

Chapter 13: Removing a Summit Family Switch from a Rack
Summit Family Switches Hardware Installation Guide
392
Removing a Switch from a Four-Post Rack
Removing the Summit X480 switch from a cabinet or four-post rack requires two people to maneuver
the switch and disconnect the mounting hardware.
To remove the Summit X480 series switch from a cabinet or four-post rack:
1 Verify that all power supplies have been removed from the switch.
2 Support the front of the switch while you remove the front rack mounting screws (Figure 333).
3 Carefully slide the switch forward out of the cabinet and off the rear mounting brackets.
Figure 333: Removing the Switch from a Four-Post Rack
4 Set the switch on a secure work surface. Using a #1 Phillips screwdriver, remove the front mounting
brackets from the sides of the switch.
5 Remove the rear mounting brackets from the rear rack posts.
SH_148