Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
274
d Tighten both screws on the terminal block to 7 inch-pounds (0.99 Newton meters) (Figure 220).
3 Snap the cover into place over the terminal block (Figure 220).
Figure 220: Connecting the DC Power Cables (Part 2)
4 Connect the cables to the DC source voltage, using hardware appropriate to the installation site and
following local and national electrical codes.
5 Energize the DC circuit.
SH_162
(+)
(–)
RTN
-48V
To Next Page
Loading...
