Chapter 5: Installing the Virtual Services
Platform 7200 Series
This section provides the information and procedures to install the VSP 7200 Series.
Installation checklist
Use this checklist to install the VSP 7200 Series.
No. Task Description
1. Mount the VSP 7200 Series in the
equipment rack.
See Installing the switch in an equipment
rack on page 40.
You have two options for installing the switch in
an equipment rack:
• Using the optional slide rack mount kit on
page 41
•
Using the supplied brackets on page 71
2. Install the primary or redundant
power supply.
Important:
A combination of AC-input and
DC-input power supplies in the
same chassis is not supported.
If you have an AC power supply, see Installing
an AC power supply on page 24.
If you have a DC power supply, see Installing a
DC power supply on page 29.
3. Install the fan modules. See Install a Fan Module on page 34.
4. Check the LEDs to verify the
installation.
For a description of the LEDs, see LED state
definitions on page 37.
March 2020 Installing the VSP 7200 Series 18
To Next Page
Loading...
Need help?
General
