Extron electronics ShareLink 200 N - Operation Using a Computer; Connecting a Computer to the Sharelink 200 N; Connecting through an External WAP; Connecting through a Network Hub, Switch, or Router

ShareLink 200 N • Operation Using a Computer 11
Operation Using a
Computer
Users can present from a Windows or Mac computer using the ShareLink Software. This
section covers the following:
• Connecting a Computer to the ShareLink 200 N
• Setting Up the ShareLink Software
• Using the ShareLink Software
NOTES:
macOS computer minimum system requirements:
• Dual Core, 1.4 GHz processor or better
• macOS 10.9 - 10.15
• Graphics card with 64 MB VRAM or better
Windows computer minimum requirements:
• Dual Core, 1.8 GHz processor or better
• Microsoft Windows 7/8/10
• Graphics card with 64 MB VRAM or better
Connecting a Computer to the ShareLink 200 N
There are two ways to connect a computer to the ShareLink 200 N: wirelessly, through an
external WAP, or wired through a network device.
Connecting through an External WAP
1. Ensure that the external WAP and the ShareLink 200 N are wired to the same network.
2. Ensure that the ShareLink 200 N is powered on and that wireless network capability is
enabled on your computer.
3. Open the wireless networks on your PC and connect to the external WAP.
Connecting through a Network Hub, Switch, or Router
1. Ensure that your computer is connected to the network through a hub, switch, or router.
2. Connect the RJ-45 connector of the ShareLink 200 N to the network device using an
RJ-45 cable.
PRELIMINARY