Extron electronics ShareLink 200 N - Reference Information; Mounting; Wall Mounting

ShareLink 200 N • Reference Information 35
Reference
Information
This section covers the following:
• Mounting
• Downloading ShareLink 200 N Firmware
Mounting
Wall Mounting
Follow these steps to mount the ShareLink 200 N on a wall using the included wall mount kit:
1. Secure the bracket to the wall using the four supplied bracket screws. Be sure to install
the bracket with the large keyhole facing upward as shown below.
2. Tighten the two small mounting screws on the bottom panel of the ShareLink 200 N as
shown below.
3. Insert the screwheads into the wall mount bracket. Ensure that the ShareLink 200 N
receiver sits securely on the bracket.
e
ShareLink 200 N
USB
2
1
RESET
Figure 30. ShareLink 200 N Wall Mount Kit
PRELIMINARY