Extron electronics ShareLink 200 N - SNMP Setup

ShareLink 200 N • Using the Embedded Web Pages 28
SNMP Setup
Simple Network Management Protocol (SNMP) facilitates the exchange of basic network
management information to provide monitoring, control, and to collect error information.
2
2
2
3
3
3
4
4
4
1
1
1
5
5
5
Figure 22. SNMP Setup
1
Enable or Disable — SNMP is enabled by default. To disable SNMP, choose Disable.
2
SNMP V2 panel — The SNMP Community and Write Community values act as
passwords, granting public (read-only) and private (read-write) access to the network
management system.
• Community — Default value is set to “public”
• Write Community — Default value is set to “private”
3
SNMP V3 panel
• User Name — Configure the user name of the person in charge of managing the
ShareLink through SNMP.
• Auth Password (MD5) — Configure the Auth password.
NOTE: The default password is “Authadmin.” To change the password, enter a
new password and click “Apply.”
• Priv Password (DES) — Configure the Priv password.
NOTE: The default password is “Privadmin.” To change the password, enter a
new password and click “Apply.”
4
Port — See Firewall Traversal on page 38 for a list of ports and their functions.
5
Trap panel — Configure the trap receiver IP.
PRELIMINARY