ShareLink 200 N • Using the Embedded Web Pages 32
Web Page Moderator Setup
Figure 25. Web Page Moderator Setup
The Web Page Moderator password is used to access the moderator page. Use this screen
to change the moderator password as follows.
NOTE: The factory configured password for all accounts has been set to the device
serial number (passwords are case sensitive). Performing a reset sets this password to
“moderate” (see Reset to Default on page 34 for reset instructions).
To change the moderator password:
1. Enter the new password in the Enter New Password field.
2. Re-enter the password in the Confirm New Password field.
3. Click Apply to activate the new moderator control password.
You may also enable or disable Web Page Moderator Access by clicking the Enable or
Disable radio buttons.
Admin Password
Figure 26. Admin Password
The Admin password is used to access the Configuration pages. Use this screen to change
the Admin password as follows.
NOTE: The factory configured password for all accounts has been set to the device
serial number (passwords are case sensitive). Performing a reset sets this password to
“configure” (see Reset to Default on page 34 for reset instructions).
1. Enter the new password in the Enter New Password field.
2. Re-enter the password in the Confirm New Password field.
3. Click Apply to activate the new moderator control password.
To Next Page
Loading...