Extron electronics ShareLink 200 N - Network Setup

ShareLink 200 N • Using the Embedded Web Pages 27
Network Setup
1
1
1
2
2
2
3
3
3
Figure 21. Network Setup
1
Host Name and Domain Name panel
• Host Name — Enter a hostname for the ShareLink or leave the default name as is.
• Domain Name — Enter the domain name for the DNS server.
2
IP Setup panel
• Obtain an IP address automatically (default setting) — Select this
option to obtain an IP address automatically from a DHCP server. The default
settings are:
IP Address: 192.168.254.254 Subnet Mask: 255.255.255.0
Default Gateway: 192.168.254.254 DNS Server: 0.0.0.0
• Use the following IP address — Select this option to enter a static IP address.
IP Address — Enter an IP address.
Subnet Mask — Enter the corresponding subnet mask.
Default Gateway — Enter the corresponding gateway address.
DNS Server — Enter the corresponding DNS server address.
3
DHCP Server Setup panel
• Auto (default setting) — If a DHCP server is available on the network, the ShareLink
uses an IP address assigned by the server. If a DHCP server is not available on the
network, the ShareLink uses its internal DHCP server to assign IP addresses to
network devices. The default settings are as follows:
Start IP: 192.168.254.11 End IP: 192.168.254.100
Subnet Mask: 255.255.255.0 Default Gateway: 192.168.254.254
DNS Server: 0.0.0.0
NOTE: In Auto mode, you may use the default settings above or customize the
settings, if needed.
• Disable — Select this option to disable the internal DHCP server.
PRELIMINARY