Extron electronics ShareLink 200 N - Webshare Setup

ShareLink 200 N • Using the Embedded Web Pages 31
WebShare Setup
1
1
1
2
2
2
Figure 24. WebShare Setup
1
Auto Refresh Interval (second) panel — Use this panel to configure the
presentation refresh interval time (the amount of time that elapses before the
presentation refreshes).
• Manual Refresh
• 10 - 90 (seconds) — Select the best option for the number of users.
2
Access Password Control panel — Use this panel to disable or configure the
WebShare access password (this is the password required when connecting to the
ShareLink 200 N through WebShare):
• Disable — Select to disable the password. This allows users to connect to the
ShareLink 200 N through WebShare without a password.
• Use the same password as “Code” — Select this option to make the
WebShare access password the same as the Code on the standby screen.
• Use the following Code — Enter a custom code to use as the WebShare
access password.
PRELIMINARY