ShareLink 200 N • Using the Embedded Web Pages 24
Configuring ShareLink 200 N Settings
To access the ShareLink 200 N admin (configuration) pages:
1. Click the Configure button on the top right hand corner of the landing page (see
figure 15,
1
, page 20). The Login page opens.
2. Enter the password and click Login. The default password is “configure”.
NOTE: The factory configured password for all accounts has been set to the device
serial number (passwords are case sensitive). Performing a reset sets this password
to “configure” (see Reset to Default on page 34 for reset instructions).
After login, the admin page opens:
Figure 19. ShareLink 200 N Admin Pages
• System Status — This is the default page. It displays basic information about the
ShareLink 200 N model, network status, connection status, and date and time.
• Device Setup — Use this page to adjust the ShareLink 200 N output resolution, login
code, date and time, and to reboot settings (see Device Setup on the page 26).
• Network Setup — Use this page to adjust network settings for the ShareLink 200
N, such as hostname, domain name, IP settings, and DHCP settings (see Network
Setup on page 27).
• SNMP Setup — Use this page to enable or disable SNMP service, and to configure
settings for managing the ShareLink 200 N via SNMP (see SNMP Setup on page 28).
• OSD Setup — Use this page to customize standby screen image or reset it to default,
and to choose which device information to display on the standby screen (see OSD
Setup on page 29).
• WebShare Setup — Use this page to set the auto refresh interval and the Access
Password Code for WebShare (see WebShare Setup on page 31).
To Next Page
Loading...