8.3. Pairing sensor
There both a sensor in the heart-rate belt and
the pedometer. Please pairing sensor before using
the heart-rate belt and the pedometer after replacing
battery. Only after pairing the sensor, the signal between
watch, heart-rate belt and pedometer and be connected.
Wearing well the heart-rate belt and turning on
the pedometer, them pairing it as following:
1)In the time mode, hold on button[B]to enter into
mode menu.
2)Press button[C]/[D]to select “Setting” (setting mode),
press button[E]to confirm.
3)Press button[C]/[D]to select “Pairing” (setting pairing),
press button[E]to begin to pairing.
About several seconds,our watch will display whether
can find heart-rate belt and pedometer or not. If find,
pairing succeed; if not, pairing failed.
Button
8.2.2.Wearing Pedometer
1) Take out the pedometer;
2) Turn on pedometer;
Hold on pedometer button for
2 seconds to turn on/off pedometer.
Green light flashing means turn on
pedometer, r ed l ig h t f l as h i n g
means turn off pedometer. Press
the button alone can review the
current status of pedometer.
3) Ties up the pedometer on the
shoelace, you can begin to run
(as the picture on the right).
The transmitter in the Hear-rate belt and pedometer
may have an impact on the medical equipment. Please
consult you doctorbefore wearing the heart-rate belt
and pedometer if you are using the medical equipment.
Pedometer
12
To Next Page