Ezviz C3A User Manual

III
Regulatory Information
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Note: This product has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This product generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this product does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Please take attention that changes or modification not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
This equipment should be installed and operated with a minimum distance 20cm
between the radiator and your body.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
EU Conformity Statement
This product and - if applicable - the supplied accessories too are
marked with "CE" and comply therefore with the applicable
harmonized European standards listed under the Radio Equipment
Directive 2014/53/EU, the EMC Directive 2014/30/EU, the RoHS
Directive 2011/65/EU.

Ezviz C3A Specifications

General

Type	IP security camera
Day/night mode	Yes
Placement supported	Indoor & outdoor
Connectivity technology	Wireless
Motion sensor technology	Passive infrared (PIR) sensor
LED type	IR
Night vision distance	7.5 m
Form factor	-
Mounting type	Wall
Product color	Black, Silver
Protection features	Dust resistant
International Protection (IP) code	IP65
Total megapixels	2 MP
Maximum resolution	1920 x 1080 pixels
Supported video modes	1080p
Video compression formats	H.264
Audio system	2-way
Compatible memory cards	MicroSD (TransFlash), SD
Maximum memory card size	128 GB
AC input voltage	100 - 240 V
Battery capacity	5500 mAh
DC output current	1 A
DC output voltage	5
Power source type	AC, Battery
AC input frequency	50 - 60 Hz
Battery technology	Lithium
Number of sensors	1
Optical sensor size	1/4 \
Frequency band	2.4 GHz
Operating temperature (T-T)	-20 - 45 °C
Operating relative humidity (H-H)	0 - 95 %
Fixed focal length	2.2 mm
Minimum illumination	- lx
Field of view (FOV) angle	126 °

Weight and Dimensions

Depth	70 mm
Width	56 mm
Height	92 mm
Weight	215 g